User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-58
To Use USB Storage
As is shown in figure 2-67, the storage location is divided into: The internal Storage
Local(C :) and the U Disk storage U Disk (A :). At the left side of the front panel, there
is a USB interface. When a USB storage is connected, the storage menu will show
“Mobile Disk (A:)”. Otherwise, the default location is the internal location Local(C :).
Figure 2-67 To Use the USB Storage
1. Install the Mobile Disk
Insert the Mobile Disk into the USB interface on the front panel, and the screen
will show “Detect a Mobile Disk”, and storage menu will show “Mobile Disk ( A:)”
2. Choose the Mobile Disk
Press Browser Directory, move the cursor with the up or down direction
key to select “Mobile Disk ( A:)”. Press the right key to open the lower directory,
use the up and down direction key to choose the file” DG3000”. Use the right key
to open the lower directory, and up and down key to select the file “Workspace”.
Input the file name and save.
3. Remove the Mobile Disk
Remove the Mobile Disk from the Interface. The system will inform you “The
Mobile Disk is removed”, and the “Mobile Disk (A:)” in the storage menu will
disappear.
Note: Mobile Disk can only be U Disk; portable hard disk is not supported.