User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-60
1. English Input
The English Input Interface is as shown in figure 2-70, to save a file named
“NewFile”, follow the steps below:
Figure 2-70 The English Input Interface
(1) Press Input Type En , to enter the English Interface.
(2) Input the file name” NewFile”.
Use the Knob to adjust the cursor’s horizontal position and the up and down key
to adjust the vertical position. Select the Character “N” and press Select. Repeat
this until you have inputted “NEWFile” . Press the +/- button on the number
Keypad to shift into the Capitalized Input mode
(3) Edit the File Name
When you have entered a wrong character, move the cursor to the wrong
character to be deleted and press Delete to remove it. Reenter the file name.
(4) Press End/Store , to finish and save the file.
File Name
Input Window
Key Pad