User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-61
2. Chinese Input
The Chinese Input Interface is as shown in figure 2-71. To save a new file named
“信号发生器”, follow the instructions below:
Figure 2-71 The Chinese Input Interface
(1) Press Input Type Chn(s) , to enter the Chinese Input Interface.
(2) Press the “+/-”button on the Number Keypad, to shift Capitalization, and choose
the input to be Minuscule and enter Chinese.
(3) Input the file name : “信号发发生器”
Use the Knob to adjust the cursor’s horizontal position and the up and down key
to adjust the vertical position. Select the Character “q” and press Select .
Repeat till all the needed characters are selected. In the Input Menu, choose the
Chinese character you need with the help of the page controller and the 1~9
button on the keypad.
(4) Edit the wrongly input
When a file name is wrong, move the cursor to the character to remove and
press Delete to remove it and reenter the file name.
(5) Press End/Store , to finish and save the file.
Notes: The length of file name user can edit is up to 24 characters or 12 Chinese
characters (The file can be stored in U-disk or non- volatile memories, but the length
of file name has the limit). The length limit in non-volatile memories is 12 characters
or 6 Chinese characters; the limit in U-disk is 39 characters or 19 Chinese characters.
If surpass the length limit, N/A is shown.
Key Pad
Input Menu
File Name
Input
Window
Page
Controller