User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-66
For the External Gated Burst, the Sync Signal follows the External Gated Signal.
But, please note that this signal will not turn Level Low until the end of the last
period (If the Waveform has a relative starting phase, it may be not zero
intersections).