User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-67
To Set Output Parameter
Press Utility Output Setup , to enter the following interface.
Figure 2-75 Table 2-37 The Menu Explanations of Output Setting (Page 1/2)
Figure 2-76 Table 2-38 The Menu Explanations of Output Setting (Page 2/2)
Note: About DG-POD-A, please refer to its User’s Guide.
Function
Menu
Settings
Explanation
Load
High Z
Set the Load connected to the Output
Connector.
Set the Load connected to the Output
Connector to be High_Z.
Range
Auto
Hold
Allow the Instrument to choose the best
Amplifier/ Attenuator
Disable the Auto Adjusting
Normal
Invert
Normal Output
Inverse Output
Adjust
Phase
Set the Phase Offset of the Output
Waveform
Digit-Modu
Power-Off
Digital Module Power On/Off
Work-Mode
Independ
Set the work-mode of Digital Output
Module (DG-POD-A) as independ work or
online work