User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-71
To Set the I/O
Press Utility I/O Setup , to set the I/O.
Figure 2-82 Table 2-40 The Menu Explanations of I/O Setup
Set the GPIB address any number between 0 and 30. The default setting is “1”.the
Address is stored in the Non-Volatile Memory, and will show when the power is on.
The I/O Setting offers the Storage and Load of the configuration parameter setting of
the GPIB（IEEE-488）, RS232 or LAN which are used for remote control. GPIB and
RS232 can not be used together.
Function
Menu
Settings
Explanation
GPIB
Address
Set the GPIB Address
LAN
Set the LAN configuration parameter
Show
USB Id
Show USB Address
RS232
Set the RS232 Interface