User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-72
1. To Set the LAN
Offer the Storage and Load Operation of the Network Configuration needed for
Remote Control of LAN Interface. You can configure IP Address, DNS setting or
check the current network configuration.
Press Utility I/O Setup LAN , to enter the following interface.
Figure 2-83 Table 2-41 The Menu Explanations of LAN Setup
Function
Menu
Settings
Explanation
IP
Setup
Set the corresponding parameter for IP
DNS
Setup
Set the corresponding parameter for
DNS
Current
Config
The current setting information about
the host