Quick Start Guide

RIGOL

Quick Guide for DG5000

1. Power Key

The power soft key is used to turn the generator on or off.

2. USB Host

Support FAT file format USB flash device, RIGOL TMC digital oscilloscope (DS)

and power amplifier (PA).

 USB flash device: Read the waveform or state files from the USB flash device,

or store the current instrument state and edited waveform data into the USB

flash device.

 TMC DS: Seamlessly interconnect with the RIGOL DS that fits the TMC

standard, read and store the waveform data sampled by the DS and display

it nondestructively.

 PA (optional): Support the RIGOL power amplifier, for example, PA1011.

Enable to be configured online and amplify the signal power before output.

3. LCD

480 × 272 TFT color LCD is used to display the current function menu and

parameters setting, system state and prompt messages.

4. Display Switch

For dual-channel model: Switch between Parameter/Graph display mode.

For single-channel model: not available.

5. Sine

Generate a Sine waveform with frequency from 1 μHz to 350 MHz.

 When the function is enabled, the backlight of the button turns on.

 Enable to change Frequency/Period, Amplitude/High Level, Offset/Low Level

and Start Phase of the Sine waveform.

6. Square

Generate a Square waveform with frequency from 1 μHz to 120 MHz and variable

duty cycle.

 When the function is enabled, the backlight of the button turns on.

 Enable to change Frequency/Period, Amplitude/High Level, Offset/Low Level,

Duty Cycle and Start Phase of the Square waveform.

7. Ramp

Generate a Ramp waveform with frequency from 1 μHz to 5 MHz and variable

symmetry.

 When the function is enabled, the backlight of the button turns on.