Quick Start Guide

RIGOL
Quick Guide for DG5000
9
impedance is 50 Ω.
For dual-channel model: enable or disable waveform signals generated from
[Output] connector corresponding to CH2.
For single-channel model: output signals of the main channel.
CAUTION
Overvoltage protection of the output channel will take effect once any of
the following conditions is met.
 Amplitude setting in the generator is greater than 2 Vpp; the input
voltage is greater than ± 12.1 V (± 0.1 V) and frequency is lower than
10 kHz.
 Amplitude setting in the generator is lower than or equal to 2 Vpp; the
input voltage is greater than ± 4.8 V (± 0.1 V) and frequency is lower
than 10 kHz.
The message “OverLoad protect, The output is off!” will appear on the
screen when overvoltage protection takes effect.