Manualshelf

User manual

ManualsBrandsRIGOL ManualsLaboratory Test EquipmentMains-powered 25 MHz (max) 1-channel Arbitrary, Triangle, Lorentz curve, Pulse, Noise, Rectangle, Sinus Ma
121122123124125126127128129130
Chapter 2 Front Panel Operations RIGOL
DG800 User's Guide 2-93
To Set the LAN Parameters
DG800 only uses the following model of the USB-LAN interface converter to expand
the LAN interface.
Manufacturer
Model
Feature
TP-LINK
TL-UF2101.0
177TL-UF210 1.0
177TH2
USB2.0, 100Mbps
UGREEN
20254
Press Utility Interface LAN to open the LAN parameters configuration
interface as shown in the figure below. You can view the network status and
configure the network parameters.
Figure 2-26 LAN Setting Interface
Network Status
Different prompt messages will be displayed based on the current network status.
Connected: indicates that the network connection is successful.
Disconnect: indicates that the network connection is failed.
Adapter not found: indicates that the network is not connected.
IP Configuration
IP configuration mode can be DHCP, AutoIP, or ManualIP. In different IP
configuration modes, the configurations for the IP address and other network
parameters are different.
1. DHCP
In DHCP mode, the DHCP server in the current network assigns the network
parameters (e.g. IP address) for the signal generator.