Datasheet

Transient test function enables the load to periodically switch between
two set levels (Level A and Level B). It can be used to test the transient
characteristics of the DUT. The highest frequency can be set to 30 kHz.
Besides, in the guide interface, you can congure parameters in the
parameter conguration list and view the conguration diagram at the left of
the conguration list in the real-time manner.
You can generate complex sequences by editing the setting value for each
step, the dwell time, and slew rate (the slew rate can only be edited in CC
mode) to meet the complex test demands.
The load allows you to save different types of les to the internal and
external memories. You can recall and read them when necessary.
When OVP/OCP/OPP/OTP/reverse voltage protection occurs, the load
will immediately turn off the input automatically and stop sinking. Then, a
prompt message is displayed.
The electronic load provides the waveform display function and supports
the following operations for the waveform, such as pausing the waveform,
recording the waveform, and capturing the waveform. Therefore, you can
dynamically observe the trend of parameters changes.
Current rising speed is dened as the speed of transition from one setting
to another. You can set the actual transition time from one setting to another
by changing the current rising speed. Adjustable current rising speed: 0.001
A/μs to 5 A/μs.
30 kHz dynamic mode 5 A/μs current rising speed
Powerful list operation function
Easy-to-use function of le storage and recalling
Powerful waveform display function
Sound OVP/OCP/OPP/OTP/Reverse Voltage
Protection
RIGOL
2
Design Features