Specifications

RIGOL Chapter 3 Commands Compatibility
Programming Guide for DM3000
3-2
Agilent Commands Compatibility
The following table lists the commands of Agilent that supported by RIGOL DM3000
series digital multimeters.
Before using the commands, please select the Agilent commands by CMDSet
command - CMDSet AGILENT. For more details on this command, please refer to the
“Commands Introduction” in Chapter 1.
NOTE: The contents in item “Function” from the table below refer to application of
Agilent Commands in RIGOL DM3000 series digital multimeters.
Agilent Commands
Function
CALCulate:AVERage:AVERage?
Queries the calculated average of all data.
CALCulate:AVERage:CLEar
Restores the setting values of all math functions
under the current measurement function to the
defaults.
CALCulate:AVERage:COUNt?
Queries the number of the calculated data.
CALCulate:AVERage:MAXimum?
Queries the maximum of the calculated data.
CALCulate:AVERage:MINimum?
Queries the minimum of the calculated data.
CALCulate:AVERage:PTPeak?
Queries the peak value of the calculated data.
CALCulate:AVERage:SDEViation?
Queries the standard deviation of the calculated
data.
CALCulate:DB:REFerence?
{MINimun|MAXimun}
CALCulate:DB:REFerence
{<value>|MINimum|MAXimum}
Query and set the dB reference value.
CALCulate:DBM:REFerence?
{MINimun|MAXimun}
CALCulate:DBM:REFerence
{<value>|MINimum|MAXimum}
Query and set the dBm reference value.
CALCulate:FUNCtion?
CALCulate:FUNCtion
{NULL|DB|DBM|AVERage|LIMit}
Query and set the calculation function.
CALCulate:LIMit:LOWer?
{MINimum|MAXimum}
CALCulate:LIMit:LOWer
Query and set the lower limit of the current
measurement function.