Specifications

RIGOL Chapter 3 Commands Compatibility
Programming Guide for DM3000
3-10
buffer.
[SENSe:]MEASure[:VOLTage][:DC]?
[{<range>|AUTO|MIN|MAX|DEF}
[,{<resolution>|MIN|MAX|DEF}]]
Resets all DC voltage measurement parameters and
trigger parameters to their defaults, and then
configures the meter for capacitance
measurements and immediately triggers a
measurement. The results are sent directly to the
instrument output buffer.
[SENSe:]MEMory:NSTates?
Queries the total number of memory locations
available for state storage.
[SENSe:]MEMory:STATe:CATalog?
Queries the names assigned to storage locations.
[SENSe:]MEMory:STATe:DELete
{0|1|2|3|4|5|6|7|8|9}
Deletes the contents of the specified storage
location.
[SENSe:]MEMory:STATe:DELete:ALL
Deletes the contents in system configuration of the
storage locations.
[SENSe:]MEMory:STATe:NAME?
{0|1|2|3|4|5|6|7|8|9}
Query and assign the file name of the specified
storage location.
[SENSe:]MEMory:STATe:RECall:AUTO?
[SENSe:]MEMory:STATe:RECall:AUTO
<mode>
Query and set the automatic recall state of a
specific stored instrument state when power is
turned on.
[SENSe:]MEMory:STATe:RECall:SELect?
[SENSe:]MEMory:STATe:RECall:SELect
{0|1|2|3|4|5|6|7|8|9}
Query and set the instrument state at power on if
the automatic recall mode is enabled.
NOTE: The command only can be responded.
[SENSe:]MEMory:STATe:VALid?
{0|1|2|3|4|5|6|7|8|9}
Queries the specified storage location to determine
if a valid state is currently stored in this location.
[SENSe:]OUTPut:TRIGger:SLOPe?
[SENSe:]OUTPut:TRIGger:SLOPe <slope>
Query and set the trigger mode (edge) of the
trigger signal from the meter.
[SENSe:]PERiod:APERture? [{MIN|MAX}]
[SENSe:]PERiod:APERture
{<second>|MIN|MAX|DEF}
Query and set the aperture time for period
measurements.
[SENSe:]PERiod:NULL[:STATe]?
[SENSe:]PERiod:NULL[:STATe] {ON|OFF}
Query and set the NULL state for period
measurements.
[SENSe:]PERiod:NULL:VALue? [{MIN|MAX}]
[SENSe:]PERiod:VALue {<value>|MIN|MAX}
Query and set the NULL value for period
measurements.
[SENSe:]PERiod:VOLTage:RANGe:AUTO?
[SENSe:]PERiod:VOLTage:RANGe:AUTO
<mode>
Query and set the voltage automatic range state for
period measurements.
[SENSe:]PERiod:VOLTage:RANGe[:UPPer]?
Query and set the voltage range for period