Specifications

Chapter 3 Commands Compatibility RIGOL
Programming Guide for DM3000
3-15
Fluke Commands Compatibility
The following table lists the commands of Fluke that supported by RIGOL DM3000
series digital multimeters.
Before using these commands, please select the Fluke commands by CMDSet
command - CMDSet FLUKE. For more details on this command, please refer to the
“Commands Introduction” in Chapter 1.
NOTE: The contents in item “Function” from the table below refer to application of
Fluke Commands in RIGOL DM3000 series digital multimeters.
Fluke
Fluke Commands
Function
AAC
Turns on the AC current measurement function.
ADC
Turns on the DC current measurement function.
VDC
Turns on the AC voltage measurement function.
VAC
Turns on the AC voltage measurement function.
CONT
Turns on the continuity measurement function.
DIODE
Turns on the diode measurement function.
FREQ
Turns on the frequency measurement function.
FREQ2
Turns on the frequency measurement function under the secondary
display while it is in AC measurement.
OHMS
Turns on the resistance measurement function.
WIRE2
Switches to the 2-wire resistance measurement function.
WIRE4
Switches to the 4-wire resistance measurement function.
FUNC1?
Queries the current main measurement function.
FUNC2?
Query the current measurement function under the secondary
display. Note this command is available only for AC measurements.
CLR2
Clears the secondary function. Note that this command is available
only when the frequency measurement function is turned on for AC
measurements.
DB
Turns on the DB measurement function.
DBCLR
Exits the DB measurement function.
DBREF <value>
Sets the DB reference value.
DBREF?
Queries the DB reference value.
HOLD
Turns on the Touch Hold function of the meter.