User manual

Chapter 1 Programming Overview RIGOL
DP700 Programming Guide 1-3
Note: If the test fails, check whether DP700 can communicate with the PC via the RS232 cable
normally, whether the current RS232 settings of the software match those of DP700.
In the dialog box shown in Figure (b), click "OK". Then the "Add" button in the "RS232 Setting" tab will
be enabled. Click "Add", and then the currently selected instrument resource will be displayed on the
right section of the window, as shown in Figure (c). Then, click "OK" to add the instrument resource.
(c)
The added RS232 instrument resource will be displayed under the "RIGOL Online Resource" directory,
as shown in Figure (d).
(d)
5. Control the instrument remotely
Right-click the resource name "DP711 (ASRL1::INSTR)", and select "SCPI Panel Control" to open the
SCPI command control panel. In the SCPI command control panel, input a correct command. After that,
click "Send Command" first and then click "Read Response". Or you can directly click "Send & Read" to
verify whether the connection works properly.
Figure 1-2 SCPI Control Panel