Manualshelf

User manual

ManualsBrandsRIGOL ManualsLaboratory & Bench PSUsBench PSU (adjustable voltage) 0 - 40 V 0 - 10 A
61626364656667686970
Chapter 2 Front Panel Operations RIGOL
DP800A User’s Guide 2-31
Display Setting
Press Display at the front panel to enter the interface as shown in the figure below.
You can set the screen brightness, contrast, RGB luminance and display mode.
Besides, you can also define the start-up interface.
Figure 2-7 Display Setting Interface
Brightness
Press Display Brightness and rotate the knob to set the brightness of the
screen. The range is from 1% to 100% and the default is 50%. This setting is stored
in the non-volatile memory and will not be affected by reset.
Contrast
Press Display Contrast and rotate the knob to set the contrast of the screen.
The range is from 1% to 100% and the default is 25%. This setting is stored in the
non-volatile memory and will not be affected by reset.
RGB Luminance
Press Display RGB Lum and rotate the knob to set the RGB luminance of the
screen. The range is from 1% to 100% and the default is 50%. This setting is stored
in the non-volatile memory and will not be affected by reset.