User`s guide

RIGOL

User‟s Guide for DS1000CA Series

2-82

Manual Mode

Press Cursor→Mode→Manual to display the manual mode menu.

Figure 2-115 Table 2-75 Manual mode menu

Settings

Comments

Mode

Manual

Adjust the cursor to measure X/Y

parameters manually.

Type

Shown as vertical line to measure the

horizontal parameters.

Shown as horizontal line to measure the

vertical parameters.

Source

CH1

CH2

MATH/FFT

Select the measurement signal source.

CurA

Set CurA effective and adjust it.

CurB

Set CurB effective and adjust it.

In this mode, the oscilloscope measures the Y or X coordinate values of the cursors,

and the increments between the two cursors.

To do manual Cursor Measurements, please do as the following steps:

1. Select the Manual mode for cursor measurement by pressing soft button as:

Cursor→Mode→Manual.

2. Select the cursors type by pressing soft button as Cursor→Type→ X or Y.

3. Select channel Source for measurements by pressing soft button as:

Cursor→Source→CH1, CH2 or MATH/FFT.

4. Move the cursors to adjust the increment between the cursors:(Details in the

following Table)