User Guide
RIGOL  Chapter 15 Accessibility Setting 
15-4  MSO1000Z/DS1000Z User’s Guide 
DHCP 
Press Configure and use   to select “DHCP”. Then press down   to select this 
type. When DHPC is valid, the DHCP server in the current network will assign the 
network parameters (such as the IP address) for the oscilloscope. 
Auto IP 
Press Configure and use   to select “Auto IP”. Then press down   to select this 
type. When the auto IP type is valid, disable DHCP manually, Gate and DNS are 
added to the right side of the screen and users can define the gateway and DNS 
server address of the oscilloscope. In auto IP mode, the oscilloscope will get the IP 
address ranging from 169.254.0.1 to 169.254.255.254 and the subnet mask 
255.255.0.0 automatically according to the current network configuration. 
Static IP 
Press Configure and use   to select “Static IP”. Then press down   to select 
this type. When this type is valid, disable DHCP and auto IP manually, IP Address, 
Mask, Gate and DNS are added to the right of the screen. At this point, users can 
define their own network parameters (such as the IP address) of the oscilloscope. 
1.  Set the IP Address 
The format of IP address is nnn.nnn.nnn.nnn. The range of the first nnn is from 
0 to 255 (except 127); wherein, the valid range is from 0 to 223. The ranges of 
the other three nnn are from 0 to 255. You are recommended to ask your 
network administrator for an IP address available. 
Press IP Address and use   to input the desired IP address. This setting will 
be saved in the non-volatile memory and if “Power-off Recall
” is set to “Last”, 
DHCP and Auto IP will be “Off” and the oscilloscope will load the preset IP 
address automatically at the next power-on. 
2.  Set the Subnet Mask 
The format of the subnet mask is nnn.nnn.nnn.nnn; wherein, the range of the 
nnn is from 0 to 255. You are recommended to ask your network administrator 
for a subnet mask available. 
Press Mask and use   to input the desired subnet mask. This setting will be 
saved in the non-volatile memory and if “Power-off Recall” is set to “Last”, 










