Instructions

Chapter 2 Command System RIGOL
DS1000Z-E Programming Guide 2-1
Chapter 2 Command System
This chapter introduces the syntax, function, parameter, and using instruction of each DS1000Z-E
command.
Main topics of this chapter:
 :AUToscale
 :CLEar
 :RUN
 :STOP
 :SINGle
 :TFORce
 :ACQuire Commands
 :CALibrate Commands
 :CHANnel<n> Commands
 :CURSor Commands
 :DECoder Commands
 :DISPlay Commands
 :ETABle Commands
 :FUNCtion Commands
 IEEE488.2 Common Commands
 :LAN Commands
 :MATH Commands
 :MASK Commands
 :MEASure Commands
 :REFerence Commands
 :STORage Commands
 :SYSTem Commands
 :TIMebase Commands
 :TRIGger Commands
 :WAVeform Commands
Note:
1. Unless otherwise noted, this manual takes DS1202Z-E as an example to introduce the commands.
2. For parameter setting commands (for example, the time, frequency, and amplitude), the oscilloscope
can only accept numbers and set the parameters using the default units; it cannot recognize the units
sent with the parameters. For the default unit of each parameter, please refer to the description in each
command in the following introductions.