Instructions

Chapter 3 Programming Demos RIGOL
DS1000Z-E Programming Guide 3-9
LabVIEW Programming Demo
The program used in this demo: LabVIEW 2009
The functions realized in this demo: read the waveform data of CH1 on the screen.
1. Run LabVIEW 2009, create a VI file and name it as DS1000Z-E_Demo.
2. Add controls. Right-click in the Front Panel interface, select and add VISA resource name and
Waveform Graph from the Controls column, as shown in the figures below.
3. Open the Block Diagram interface. Right-click on the VISA resource name and you can select and
add the following functions from VISA Palette from the pop-up menu: VISA Write, VISA Read,
VISA Open, and VISA Close.