User Manual

RIGOL Chapter 14 Remote Control
14-6 DS1000Z-E User Guide
Remote Control via LAN
1. Connect the device
Connect the oscilloscope to your LAN using a network cable.
2. Configure network parameters
Configure the network parameters of the oscilloscope according to the
description in "LAN Configuration".
3. Search for device resource
Start up Ultra Sigma, click and the panel as shown in the figure
below is displayed. Click and the instrument will automatically
search for the instrument resource currently connected to the local network. The
name of the instrument resource found will be displayed at the right side of the
panel. You can click to add the instrument resource.
4. View the device resource
The resources found will appear under the "RIGOL Online Resource" directory.
For example, DS1202Z-E (TCPIP::172.16.3.94::INSTR).
5. Control the instrument remotely
Right click the resource name "DS1202Z-E (TCPIP::172.16.3.94::INSTR)" and
select "SCPI Panel Control" to turn on the remote command control panel
through which you can send commands and read data.
6. Load LXI webpage
As this oscilloscope conforms to LXI CORE 2011 DEVICE standards, you can load
LXI webpage through Ultra Sigma (right-click the instrument resource name and
select "LXI-Web"). Various important information about the oscilloscope
(including the model number, manufacturer, serial number, description, MAC
address and IP address) will be displayed on the webpage. In addition, you can
also load LXI webpage by directly inputting the IP address of the instrument into
the address bar of the PC browser.