User Manual

Chapter 1 Disassembly and Assembly RIGOL
DS1000Z-E Service Guide 1-5
Disassemble the Metal Rear Panel
Figure 1-3 Disassemble the Metal Rear Panel
Part Description:
① 11 screws (M3x6 torx flat head countersunk screw, used for fastening the metal
front panel and the metal rear panel); not all screws are indicated in the above
figure.
Disassembly Steps:
1. Use the BNC socket wrench to remove 1 nut and washer at the BNC port on the
metal rear panel.
2. Use the T10 screwdriver to remove the 11 screws (①) that secure the metal
front metal panel and the metal rear panel.
3. Remove the power cable and fan cable from the main board and take off the
metal rear panel gently.
Tip:
 Before disconnecting the power cable and the fan cable from the main board,
pay attention to the connecting positions of the cables to avoid incorrect
connection or incomplete connection when assembling the cables.
 Before assembling the metal rear panel, check whether the screen cable and
keyboard cable on the main board are properly installed.
Metal Rear Panel
①
①
①
①
①
①
①
BNC Nut