User Guide
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DS2000 Series Overview
- Document Overview
- 1 Quick Start
- 2 To Set the Vertical System
- 3 To Set the Horizontal System
- 4 To Set the Sample System
- 5 To Trigger the Oscilloscope
- 6 To Make Measurements
- 7 Protocol Decoding
- 8 Reference Waveform
- 9 Pass/Fail Test
- 10 Waveform Record
- 11 Display Control
- 12 Store and Recall
- 13 System Function Setting
- 14 Remote Control
- 15 Troubleshooting
- 16 Specifications
- 17 Appendix
- Index
RIGOL 5 To Trigger the Oscilloscope
DS2000 User’s Guide
5-44
Trigger Output Connector
The trigger output connector at the rear panel can output trigger signals determined
by the current setting.
Press Utility AuxOutput to select “TrigOut”. When the oscilloscope is triggered,
it will output a trigger signal determined by the current trigger setting through the
[Trigger Out] connector.
Trigger Output Connector