User Guide
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DS2000 Series Overview
- Document Overview
- 1 Quick Start
- 2 To Set the Vertical System
- 3 To Set the Horizontal System
- 4 To Set the Sample System
- 5 To Trigger the Oscilloscope
- 6 To Make Measurements
- 7 Protocol Decoding
- 8 Reference Waveform
- 9 Pass/Fail Test
- 10 Waveform Record
- 11 Display Control
- 12 Store and Recall
- 13 System Function Setting
- 14 Remote Control
- 15 Troubleshooting
- 16 Specifications
- 17 Appendix
- Index
6 To Make Measurements RIGOL
DS2000 User’s Guide
6-21
Frequency Counter Measurement
The hardware frequency counter supplied with this oscilloscope can make more
precise measurement of the input signal frequency.
Press Measure Counter to select CH1 or CH2 as the measurement source. The
measurement result is displayed at the upper right corner of the screen and you can
identify the current measurement source according to the color of the icon. The
following figure is the result of frequency measurement of the input signal of CH1.
Select “OFF” to disable the frequency counter measurement function.