User Guide

ManualsBrandsRIGOL ManualsDigital OscilloscopesDigital Oscilloscope

161

162

163

164

165

166

167

168

169

170

Table Of Contents

Guaranty and Declaration
Safety Requirement
- General Safety Summary
- Safety Terms and Symbols
- Measurement Category
- Ventilation Requirement
- Working Environment
- General Care and Cleaning
- Environmental Considerations
DS2000 Series Overview
Document Overview
1 Quick Start
- General Inspection
- Appearance and Dimensions
- To Prepare the Oscilloscope for Use
- Front Panel Overview
- Rear Panel Overview
- Front Panel Function Overview
2 To Set the Vertical System
- To Enable the Channel
- Channel Coupling
- Bandwidth Limit
- Probe Ratio
- Waveform Invert
- Vertical Scale
- Vertical Expansion
- Amplitude Unit
- Channel Label
- Delay Calibration
3 To Set the Horizontal System
- Delayed Sweep
- Time Base Mode
- Horizontal Scale
- Horizontal Reference
4 To Set the Sample System
- Acquisition Mode
- Sample Mode
- Sample Rate
- Memory Depth
- Antialiasing
5 To Trigger the Oscilloscope
- Trigger Source
- Trigger Mode
- Trigger Coupling
- Trigger Holdoff
- Noise Rejection
- Trigger Type
- Trigger Output Connector
6 To Make Measurements
- Math Operation
- Auto Measurement
- Cursor Measurement
7 Protocol Decoding
- Parallel Decoding
- RS232 Decoding (Option)
- I2C Decoding (Option)
- SPI Decoding (Option)
8 Reference Waveform
- To Enable REF Function
- To Set the Color
- To Select REF Source
- To Save to Internal Memory
- To Adjust REF Waveform Display
- To Export to Internal or External Memory
- To Import from Internal or External Memory
9 Pass/Fail Test
- To Enable Pass/Fail Test
- To Select Source
- Mask Range
- Test and Ouput
- To Save the Test Mask
- To Load the Test Mask
10 Waveform Record
- Waveform Record
- Record Constant On
- Waveform Playback
- Waveform Analysis
  - Analysis Based on Trace
  - Analysis Based on Pass/Fail Mask
11 Display Control
- To Select the Display Type
- To Set the Persistence Time
- To Set the Waveform Intensity
- To Set the Screen Grid
- To Set the Grid Brightness
- To Set the Menu Display
12 Store and Recall
- Storage System
- Storage Type
- Internal Storage and Recall
- External Storage and Recall
- Disk Management
- Factory
13 System Function Setting
- Remote Interface Configuration
- System-related
14 Remote Control
- Remote Control via USB
- Remote Control via LAN
- Remote Control via GPIB
15 Troubleshooting
16 Specifications
17 Appendix
- Appendix A: Accessories and Options
- Appendix B: Warranty
- Appendix C: Any Question or Comment?
Index

RIGOL 7 Protocol Decoding

DS2000 User’s Guide

7-4

5. Decoding Table

The decoding table displays the decoded data and the corresponding line

number and time in table format. It can be used to observe relatively longer

decoded data to solve the problem that some data could not be seen clearly on

the screen.

Press Event Table  Event Table to select “ON” (note that this operation is

only available when BusStatus is set to “ON”) to enter the decoding table

interface as shown in the figure below. The decoding table lists the decoded

data in time order. If an USB storage device is currently connected to the

instrument, press Export to export the data table to the external USB storage

device in CSV format.