User Guide
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DS2000 Series Overview
- Document Overview
- 1 Quick Start
- 2 To Set the Vertical System
- 3 To Set the Horizontal System
- 4 To Set the Sample System
- 5 To Trigger the Oscilloscope
- 6 To Make Measurements
- 7 Protocol Decoding
- 8 Reference Waveform
- 9 Pass/Fail Test
- 10 Waveform Record
- 11 Display Control
- 12 Store and Recall
- 13 System Function Setting
- 14 Remote Control
- 15 Troubleshooting
- 16 Specifications
- 17 Appendix
- Index
RIGOL 7 Protocol Decoding
DS2000 User’s Guide
7-8
8. The Error Expression during Decoding
DS2000 makes full use of the resources such as color and view to express the
results of the protocol decoding effectively so as to let users find the desired
information quickly.
End Frame Error:
Errors generated when the end frame condition is not met. When the stop bit is
set to 1.5, red error mark (note that the red mark is displayed in different modes
according to the horizontal time base setting; when the horizontal time base is
relatively smaller,
is displayed; otherwise, is displayed) will be displayed if
the stop bit is less than 1.5.