User Guide
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DS2000 Series Overview
- Document Overview
- 1 Quick Start
- 2 To Set the Vertical System
- 3 To Set the Horizontal System
- 4 To Set the Sample System
- 5 To Trigger the Oscilloscope
- 6 To Make Measurements
- 7 Protocol Decoding
- 8 Reference Waveform
- 9 Pass/Fail Test
- 10 Waveform Record
- 11 Display Control
- 12 Store and Recall
- 13 System Function Setting
- 14 Remote Control
- 15 Troubleshooting
- 16 Specifications
- 17 Appendix
- Index
10 Waveform Record RIGOL
DS2000 User’s Guide
10-11
9. Time Tag
The time tag is used to display the absolute recording time of each frame of the
waveform currently recorded. Press Time Tag to enable or disable the time tag
function. When it is enabled, the time tag information is displayed at the upper
right corner of the screen as shown in the figure below.
T
0
:
display the absolute starting time of the waveform record in
“Hour:Minute:Second Month Date” format.
△T: display the recording time deviation of the current waveform relative to the
first frame of waveform.