User Guide
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DS2000 Series Overview
- Document Overview
- 1 Quick Start
- 2 To Set the Vertical System
- 3 To Set the Horizontal System
- 4 To Set the Sample System
- 5 To Trigger the Oscilloscope
- 6 To Make Measurements
- 7 Protocol Decoding
- 8 Reference Waveform
- 9 Pass/Fail Test
- 10 Waveform Record
- 11 Display Control
- 12 Store and Recall
- 13 System Function Setting
- 14 Remote Control
- 15 Troubleshooting
- 16 Specifications
- 17 Appendix
- Index
RIGOL 13 System Function Setting
DS2000 User’s Guide
13-12
Aux Output
Users can set the type of the signal output from the [Trigger Out] connector at the
rear panel.
Press Utility AuxOutput to select the desired output type.
1. TrigOut
After this type is selected, the oscilloscope outputs a signal that can reflect the
current capture rate of the oscilloscope at each trigger.
2. PassFail
After this type is selected, the oscilloscope will output a pulse signal when failed
waveforms are detected. This signal can be connected to other control systems
to conveniently view the test results.