User Guide
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DS2000 Series Overview
- Document Overview
- 1 Quick Start
- 2 To Set the Vertical System
- 3 To Set the Horizontal System
- 4 To Set the Sample System
- 5 To Trigger the Oscilloscope
- 6 To Make Measurements
- 7 Protocol Decoding
- 8 Reference Waveform
- 9 Pass/Fail Test
- 10 Waveform Record
- 11 Display Control
- 12 Store and Recall
- 13 System Function Setting
- 14 Remote Control
- 15 Troubleshooting
- 16 Specifications
- 17 Appendix
- Index
RIGOL 16 Specifications
DS2000 User’s Guide
16-4
Condition
Pulse Polarity Positive, Negative
Pulse Width Range 2 ns to 4 s
Windows Trigger
Windows Type Rising, Falling, Rising&Falling
Trigger Position Enter, Exit, Time
Windows Time 16 ns to 4 s
Nth Edge Trigger
Edge Type Rising, Falling
Idle Time 16 ns to 10 s
Edge Number 1 to 65535
Slope Trigger
Slope Condition Positive Slope (greater than, lower than, within specific
interval)
Negative Slope (greater than, lower than, within specific
interval)
Time Setting 2 ns to 4 s
Video Trigger
Signal Standard
Support standard NTSC, PAL and SECAM broadcasting
standards; support
480P, 576P, 720P, 1080P and 1080I HDTV
standards
Pattern Trigger
Pattern Setting H, L, X, Rising, Falling
Delay Trigger
Edge Type Rising, Falling
Delay Type >, <, <>, ><
Delay Time 2 ns to 4 s
TimeOut Trigger
Edge Type Rising, Falling, Rising&Falling
Timeout time 16 ns to 4 s
Duration Trigger
Pattern H, L, X
Trigger Condition >, <, <>
Duration Time 2 ns to 4 s
Setup/Hold Trigger
Edge Type Rising, Falling










