Manualshelf

User manual

ManualsBrandsRIGOL ManualsLaboratory Test EquipmentDigital 200 MHz 2-channel 1 null 7 null 8 Bit Calibrated to Manufacturer standards Digital storage (DSO)
161162163164165166167168169170
7 Protocol Decoding RIGOL
DS2000A User’s Guide
7-11
Press BusStatus to turn the bus display on or off.
4. Decoding Table
The decoding table displays the decoded data, the corresponding line number,
time, data direction, ID and ACK information in table format.
Press Event Table Event Table to select “ON” (note that this operation is
only available when BusStatus is set to “ON”) to enter the decoding table
interface as shown in the figure below. If a USB storage device is currently
connected to the instrument, you can export the data table to the external USB
storage device in CSV format.
5. Address Information during Decoding
In I2C bus, the front part of each frame of data contains the address information
and blue patches are used to represent address ID. In the ID, “Write” is used to
represent writing address and “Read” is used to represent reading address.
Press Include R/W. When “Open” is selected, AddrBits will include the “R/W”
bit as a part of the address value.