User manual

RIGOL Chapter 3 Remote Control
User’s Guide for DSA700 Series
3-10
4) Search device resource
Start-up Ultra Sigma and click
to open the panel as shown
in the figure below. Then, click "Search" and the software starts
searching for the GPIB device resources connected to the PC
automatically. When a GPIB resource is found, its device source
descriptor will be displayed on the right side of the panel.
If resources cannot be found automatically:
 Select the GPIB card address of the PC and the GPIB address of the
analyzer from the "GPIB::" and "INSTR::" dropdown boxes
separately.
 Click "Test" to see if the GPIB communication works normally; if not,
please follow the prompt messages step by step.
5) View the resource
Click
and return back to the main interface of Ultra Sigma.
The resources found are shown under the "RIGOL Online Resource"
catalog.
For example: DSA710 (GPIB0::1::INSTR).
6) Communication test
Right-click the resource name DSA710 (GPIB0::1::INSTR) and select
SCPI Panel Control to open the remote control panel from which you
can write commands and read data.