Specifications

RIGOL
DS6000 User’s Guide
6-34
Auto Mode
In this mode, one or more cursors will appear. You can use auto cursor measurement
to measure anyone of the 22 waveform parameters. Before using this mode, you
need to at least turn on one auto measurement parameter and the number of
cursors will change with the measurement parameters.
Press CURS  Mode  “Auto” and the cursor corresponding to the measurement
parameter which is turned on firstly will be displayed on the screen (different
measurement parameters need different number of cursors). Note that no cursor will
be displayed if no auto cursor measurement parameter is selected or no
measurement source is input. When the waveform is expanded or compressed
horizontally, the cursor will move accordingly.
If multiple measurement parameters are turned on later, you can use the Meas Para
softkey to switch to the desired parameter.
The following figure shows the example of auto measurement of the delay of two
channels.