Specifications

RIGOL
DS6000 User’s Guide
7-2
Parallel Decoding
Parallel bus consists of clock line and data line. As shown in the figure below, CLK is
the clock line, while Bit0 and Bit1 are the 0 bit and 1 bit on the data line respectively.
Bit0
Bit1
CLK
The oscilloscope will sample the channel data on the rising edge, falling edge or the
rising&falling edges of the clock and judge whether each data point is logic “1” or
logic “0” according to the preset threshold level.
Press MATH  BUS1  Decode to select “Parallel” and turn on the parallel
decoding function menu.
1. Clock Line Setting (CLK)
Press CLKChannel to select any channel (CH1-CH4) as the clock channel. If
“None” is selected, no clock channel is set.
Press Slope to select to sample the channel data on the rising edge ( ),
falling edge ( ) or rising&falling edges ( ). If clock channel is not
selected, the instrument will sample when the channel data is jumping in the
decoding.
2. Data Line Setting
 Set the data bits
Press Data Bits to set the data width of the parallel bus namely the number
of bits per frame. The default is 1 and the maximum is 20 bits (Bit0,
Bit…Bit19).
 Specify data channel for each bit.
First, press ChanBits to select the bit that need to specify channel. The
default is 0 and the range available is always 1 smaller than the data width.
For example: when the data width is 20, the range available is 0, 1…19.