Specifications

RIGOL
DS6000 User’s Guide
7-13
CAN Decoding (Option)
Press MATH  BUS1  Decode and select “CAN” to open the CAN decoding
function menu.
1. Source
Press the Source softkey and select any channel (CH1-CH4) as the source
channel.
2. Signal Type
Press the Signal Type softkey to select the desired signal type.
 CAN_H: the actual CAN_H differential bus signal.
 CAN_L: the actual CAN_L differential bus signal.
 Differential: The CAN differential bus signals connected to an analog
channel using a differential probe. Connect the probe’s positive lead to
CAN_L and connect the negative lead to CAN_H.
3. Baud
Press the Baud softkey to select a baud rate (100 kb/s, 125 kb/s, 250 kb/s, 400
kb/s, 500 kb/s, 800 kb/s, 1 Mb/s or User) that matches your CAN bus signal.
When “User” is selected, press the Setup softkey and use to enter the
desired rate, the range is from 10 kb/s to 1 Mb/s.
4. Sample Point
The Sample point is the point within the bit’s time. The oscilloscope samples the
bit level at this point. “Sample point” is represented by the percentage of “the
time from the start of the bit’s time to the sample point” in the “bit’s time”.
Press the Sample Point softkey and use to adjust this parameter with a
step of 1%. The range is from 5% to 95%.
1bit
60%
70%
80%