Specifications

RIGOL
DS6000 User’s Guide
9-3
To Select Source
Press Source to select the channel (CH1-CH4) to be tested. During the test, the
oscilloscope will judge whether each frame of waveform in the source complies with
the current test mask and those waveforms pass through the mask area is
considered as failed.
To Create Mask
Users can define their own test masks.
Press Enable Test to turn the mask display area on. Press X Mask and Y Mask
respectively and turn , the mask lines appear on the screen. Press Create Mask
to apply the mask currently created. The ranges of the horizontal and vertical
adjustments are from 0.02 div to 4 div and 0.03 div to 4 div respectively.
Test and Output
Before the test, you can use the following method to set the output mode of the test
results.
Press Msg Display to select “ON” or “OFF”. When “ON” is selected, the test results
will be displayed at the upper right corner of the screen.
Press Stop On Outp to select “ON” or “OFF”.
 ON: when failed waveforms are detected, the oscilloscope will stop the test and
enter the “STOP” state. At this point, the results of the test remain the same
with the display on the screen (if display is turned on) and the [Trig
Out/Calibration] (if enabled) connector at the rear panel only output a pulse.
 OFF: the oscilloscope will continue with the test even though failed waveforms