Specifications

RIGOL
DS6000 User’s Guide
9-4
are detected. The test results on the screen will update continuously and the
[Trig Out/Calibration] connector at the rear panel will output a pulse each time a
failed waveform is detected.
Press Output to select “Fail” or “Fail+ ”.
 Fail: when failed waveforms are detected, there are display and output but the
beeper does not sound.
 Fail+ : when failed waveforms are detected, there are display and output and
the beeper sounds (not related to the on/off state of the sound).
Press AuxOutput to quickly turn “ON” or “OFF” the measurement output from the
[Trig Out/Calibration] connector at the rear panel. You can also press UTIL 
AuxOutput and select “PassFail” to set this output.
To Save the Test Mask
Users can save the current test mask to the Flash memory inside the instrument or
external USB flash device. The file format of the test mask file is “*.pf”. The internal
memory can store at most 10 test mask file (LocalPF.pf).
Press Save to enter file saving interface. Please refer to the relative description in
“Store and Recall” to save the test mask file to the internal or external memory.
To Load the Test Mask
Users can also load the test mask files (*.pf) stored in the Flash memory inside the
instrument or the external USB flash device to the internal memory.
Press Load to enter the file loading interface. Please refer to the relative description
in “Store and Recall” to load the test masks to the internal memory of the
instrument.