Specifications

RIGOL
DS6000 User’s Guide
10-4
Waveform Playback
Waveform playback can play back the waveforms currently recorded. Press UTIL 
Record  Mode and use to select “Play Back”. At this point, the information as
shown in the figure below is displayed at the upper left corner of the screen,
indicating the specific frame currently displayed on the screen. During the playback,
this value would change continuously.
Please refer to the following descriptions to set the playback parameters.
1. Play Mode
Press this softkey to select the playback mode to cycler or single.
 : cycler playback. Play from the start frame to the end frame and
then repeat until you stop it manually.
 : single playback. Play from the start frame to the end frame and
then stop.
2. Interval
Press this softkey and use to set the time interval of the playback. The range
availbale is from 100 ns to 10 s and the default is 100 ns.
3. Start Frame
Press this softkey and use to set the start frame of the playbak. The default
is 1 and the maximum is the maximum number of frames recorded.
4. Current Frame
Press this softkey and use or the Navigation knob (large scale adjustment)
to set the current frame. The default is 1 and the maximum is the maximum
number of frames recorded.
During the setting, the screen will display the corresponding waveform of the
current frame synchronously, namely manual playback.
If you perform the playback operation after setting this parameter, this menu will
adjust to the value corresponding to the Start Frame and will change
continuously during the playback process.