Specifications

RIGOL
DS6000 User’s Guide
13-2
Remote Interface Configuration
DS6000 can communicate with PC via LAN, USB and GPIB (together with the USB to
GPIB module of RIGOL) buses. Please refer to the introduction below to configure
the corresponding interface before using the remote interfaces.
LAN Setting
Press UTIL  IO Setting  LAN Set to turn on the LAN setting interface. You can
view the network connection status and configure the network parameters.
Network Status
Connect the oscilloscope to your local area network using the network cable. The
network hole of the oscilloscope is at the rear panel. The oscilloscope will give
different prompts according to the current network connection status.
 Net Config Success!
 Acquire IP…
 IP Conflict!
 Unconnected!
 DHCP Fail!
 Read Status Fail!
Network Status
Current IP
Config Type
MAC Address
VISA Address
IP Config Type
Status