User`s guide

Chapter 2 Front Panel Operations RIGOL
DSG3000 User’s Guide 2-61
I/O Configuration
The RF signal generator supports LAN, USB and GPIB interface communication.
Press System  I/O Config to set the “Remote I/O”, “LAN” or “GPIB” parameters.
1. Remote I/O
Press Remote I/O to select “LAN”, “USB”, “GPIB”, “Auto” or “Off” and the
default is “Off”.
2. LAN
Press LAN to set the LAN parameters.
Figure 2-5 To Set the LAN Parameters
 Reset
Turn on the DHCP and auto IP and turn off the manual IP. Clear the network
password set to restore it to factory setting.
 Apply
After configuring LAN parameters, press Apply  OK to effect the
configuration.
 DHCP
One of the IP address setting methods. Turn on the DHCP and the DHCP
server will assign network parameters (such as the IP address, subnet mask
and gateway) for the RF signal generator according to the current network
configuration.
 Auto-IP
One of the IP address setting methods. Turn on the auto IP and the RF