User`s guide

RIGOL Chapter 3 Remote Control
3-8 DSG3000 User’s Guide
Control Via GPIB
1. Connect the devices
Connect the RF signal generator to the PC using GPIB cable.
2. Install the device driver of the GPIB card
Install the driver of the GPIB card which has been connected to the PC.
3. Set the GPIB address
Set the GPIB address following with “I/O Config  GPIB”.
4. Search device resource
Start-up the Ultra Sigma and click
to enter the following interface.
Then, click Search and the software starts searching the RF signal generator
resources that that have been connected to PC via GPIB automatically. When a
GPIB resource is found, the name of which will be displayed on the right side of
the panel.
Figure 3-6 GPIB Setting
If resources cannot be found automatically:
 Select the GPIB card address of the PC and RF signal generator from the
combo Box of “GPIB::” and “::INSTR” separately.
 Click “Test” to see if the GPIB communication works normally, if not, please
follow the prompt messages step by step.
5. View the resource
Click
and back to the main interface of Ultra Sigma. The resources
that have been searched successfully at present are shown in the “RIGOL Online
Resource” catalog.