User`s guide

RIGOL Chapter 4 Application Examples
4-4 DSG3000 User’s Guide
3. Enable the RF sweep
Press SWEEP  Sweep and select “Freq & Level” to enable the frequency and
amplitude sweep functions at the same time.
At this point, the RF signal generator sweeps from the start frequency or level to
the stop frequency or level continuously at certain step according to the current
settings. The frequency and amplitude sweep progress bars as well as the
continuous sweep label are displayed in the frequency and amplitude areas in
the user interface respectively.
4. Enable the RF output
Press RF, the backlight goes on and the RF label is displayed in the status bar of
the user interface. The RF output is enabled. At this point, the [RF OUTPUT
50Ω] connector outputs RF sweep signal according to the current configuration.