User`s guide

RIGOL Chapter 2 Front Panel Operations
2-2 DSG3000 User’s Guide
To Set the Frequency Parameters
Frequency
Set the RF output frequency.
Press FREQ  Frequency, use the numeric keyboard to input the value of the
frequency and select the desired unit from the pop-up unit menu or unit keys.
 The frequency units available are GHz, MHz, kHz and Hz.
 Press Enter to select the default unit (Hz).
 You can also press the left/right direction keys to enter the parameter editing
state and move the cursor to the specified digit; and then use the up/down
direction keys or knob to modify the value.
 After the frequency is set, you can use the up/down direction keys or knob to
modify the frequency at the current step.
 Press FREQ  Frequency and then press Step to set the step.
Frequency Offset
Set the frequency offset relative to the RF output frequency.
When using an external mixer and other devices, you can set and read the frequency
value through the external mixer on the RF source by setting the frequency offset.
Press FREQ  Offset, use the numeric keyboard to input the value of the frequency
offset and select the desired unit from the pop-up unit menu or unit keys.
 The frequency offset units available are GHz, MHz, kHz and Hz.
 Press Enter to select the default unit (Hz).
 You can also press the left/right direction keys to enter the parameter editing
state and move the cursor to the specified digit; and then use the up/down
direction keys or knob to modify the value.
 You can also use the up/down direction keys or knob to modify the frequency
offset at the current step.
 Press FREQ  Offset and then press Step to set the step.