User`s guide

RIGOL Chapter 2 Front Panel Operations
2-4 DSG3000 User’s Guide
To Set the Amplitude Parameters
Amplitude
Set the RF output amplitude.
Press LEVEL  Level, use the numeric keyboard to input the amplitude value and
select the desired unit from the pop-up unit menu or unit keys.
 The amplitude units available are dBm, -dBm, mV, μV and nV.
 Press Enter to select the default unit (dBm).
 You can also press the left/right direction keys to enter the parameter editing
state and move the cursor to the specified digit and then use the up/down
direction keys or knob to modify the value.
 You can also use the up/down direction keys or knob to modify the amplitude at
the current step.
 Press LEVEL  Level and then press Step to set the step.
Amplitude Limit
Set the limit of the RF output amplitude. This value is the upper limit of the RF output
amplitude.
To limit the output amplitude, you can use the amplitude limit function to avoid
damage caused by delivering a high powered signal to the external circuit.
Press LEVEL  Limit, use the numeric keyboard to input the value of the amplitude
limit and select the desired unit from the pop-up unit menu or unit keys.
 The amplitude limit units available are dBm, -dBm, mV, μV and nV.
 Press Enter to select the default unit (dBm).
 You can also press the left/right direction keys to enter the parameter editing
state and move the cursor to the specified digit; and then use the up/down
direction keys or knob to modify the value.
 You can also use the up/down direction keys or knob to modify the amplitude
limit at the current step.
 Press LEVEL  Limit and then press Step to set the step.