User`s guide

Chapter 2 Front Panel Operations RIGOL

DSG3000 User’s Guide 2-11

Sweep Type

DSG3000 provides two sweep types (“List” and “Step”) and the default is “Step”.

List Sweep

1. Select the list sweep mode

Press SWEEP  Type to select “List”. At this point, the RF signal generator

sweeps according to the current sweep list.

2. Create the sweep list

Press SWEEP and use the page up/down key

to open the 2/3 menu page;

then, press List Swp to enter the editing interface of sweep list.

Line number. You can add and delete rows using Insert and Delete.

Freq

Frequency.

The sweep list can contain up to 6001 frequency points. These

frequency points can locate in any frequency segment within the

maximum frequency range available. You can save sweep lists

applicable to different test settings or frequency ranges and recall

different sweep list when required.

Level

Amplitude. It is the corresponding amplitude value of the frequency

point. The sweep list can contain up to 6001 level points.

Time

Dwell time. The duration of a sweep step.

 Amplitude Calibration

Press Amp Cal, you can turn on or turn off the measuring sweep list

function with power meter. At this point, you can also record the error

value.

NOTE: The menu is activated when a USB power sensor is connected and

power meter controller (option) is installed, otherwise the menu is grayed

out and disabled.

 Insert

Press Insert to insert a row with the same sweep values below the current

row. At this point, the number of rows of the sweep list increases by one.

 Delete

Press Delete to delete the sweep values of the row currently selected. At

this point, the number of rows of the sweep list reduces by one.

 Goto Row

Press Goto Row to select the desired row for edit in the pop-up menu. It is