User`s guide

Chapter 2 Front Panel Operations RIGOL
DSG3000 User’s Guide 2-41
Explanation
The ranges of sine and sweep-sine frequency are from 100 mHz to 1 MHz.
The range of square waveform frequency is from 100 mHz to 20 kHz.
The ranges of triangle and ramp waveform frequency are from 100 mHz to
100 kHz.
Sweep-Sine Waveform
The sweep-sine waveform refers to sine waveform changes gradually from the start
frequency to stop frequency within the specified time, namely frequency sweep.
1. Select the sweep-sine
Press  LF  Waveform to select “Swp-Sine”. At this point, the RF
signal generator output sweep-sine signal from [LF OUTPUT] connector at the
front panel according to the current setting.
2. Set the sweep-sine parameters
 Start Frequency
Press Start Freq, use the numeric keyboard to input the value of the start
frequency and select the desired unit from the pop-up unit menu or unit
keys. You can also press Enter to select the default unit (Hz).
 Stop Frequency
Press Stop Freq, use the numeric keyboard to input the value of the stop
frequency and select the desired unit from the pop-up unit menu or unit
keys. You can also press Enter to select the default unit (Hz).
NOTE: After the “Start Freq” or “Stop Freq” is modified, the instrument will
restart the sweep and output from the “Start Freq” to “Stop Freq”.
 Amplitude
Press Level, use the numeric keyboard to input the value of the amplitude
and select the desired unit from the pop-up unit menu or unit keys. You can
also press Enter to select the default unit (V).
 Sweep Time
The sweep time refers to the duration of a sweep.
Press Sweep Time, use the numeric keyboard to input the time value and
select the desired unit from the pop-up unit menu or unit keys. You can also
press Enter to select the default unit (s).