User`s guide

Chapter 2 Front Panel Operations RIGOL
DSG3000 User’s Guide 2-57
selection area. If the desired pinyin is displayed, refer to step c). If
the desired pinyin is not displayed, input the whole pinyin and then
refer to c).
c) Press the left/right direction keys or rotate the knob until the
background of the desired pinyin turns red. Press Enter to select that
pinyin. At this point, the Chinese characters in the Chinese character
selection area are numbered. Use the numeric keys to select the
desired Chinese character. You can use the up/down direction keys or
rotate the knob to open the previous page and next page of the
Chinese character selection area.
d) Use the same method to input the other Chinese characters.
 Input number filename
If you want to use numbers as the filename (or a part of the filename),
press
to switch to number input mode and use the numeric keyboard
to input the desired numbers.
4. Save the file
After inputting the filename in the filename input interface, press OK and the RF
signal generator will save the file with the specified filename in the specified file
type under the directory currently selected. Press Cancel to cancel the save
operation.
 Replace File: when the current path has contained a file or folder with the
same name, you can press this key to replace the original file or folder.
 Reenter: when the current path has contained a file or folder with the same
name, you can press this key to back the filename input interface and
reenter the filename.
Recall
After selecting a file stored, press Recall to read the file selected and load it into the
system.
Rename
Modify the filename of the stored file.
After selecting a file stored, press Rename to enter the filename input interface,
edit a new filename by referring to the introduction in “
Input the filename” and
press OK to store the file with the new filename.