Instructions

RIGOL Chapter 4 Programming Demos
4-14 DSG800 Programming Guide
2) Click "MOD" to turn on the modulation output and the control above the MOD button turns yellow
(as shown in the figure below). At this point, the RF signal generator can output the RF modulated
signal via the [RF OUTPUT 50Ω] connector if the RF output is turned on. Click "MOD" again to
turn off the modulation output and the control above the MOD button turns gray.
3) Click "RF" to turn on the RF output and the control above the RF button turns yellow (as shown in
the figure below). At this point, the RF signal generator can output RF signal via the [RF
OUTPUT 50Ω] connector according to the current configuration. Click "RF" again to turn off the
RF output and the control above the RF button turns gray.