Instructions

RIGOL Chapter 2 Command System
2-12 DSG800 Programming Guide
:SOURce Commands
The :SOURce commands are used to set the related parameters of the main functions of the RF signal
generator including the frequency, level, flatness calibration, AM, FM/ØM, Pulse, SWEEP, LF output and so
on.
Command List:
 [:SOURce]:AM Command Subsystem
 [:SOURce]:CORRection Command Subsystem
 [:SOURce]:FM Command Subsystem
 [:SOURce]:FMPM:TYPE
 [:SOURce]:FREQuency Command Subsystem
 [:SOURce]:INPut:TRIGger:SLOPe
 [:SOURce]:IQ Command Subsystem
 [:SOURce]:LEVel Command Subsystem
 [:SOURce]:LFOutput Command Subsystem
 [:SOURce]:MODulation:STATe
 [:SOURce]:PM Command Subsystem
 [:SOURce]:PULM Command Subsystem
 [:SOURce]:SWEep Command Subsystem
[:SOURce]:AM Command Subsystem
Command List:
 [:SOURce]:AM[:DEPTh]
 [:SOURce]:AM[:DEPTh]:STEP[:INCRement]
 [:SOURce]:AM:EXT:COUP
 [:SOURce]:AM:EXT:IMP
 [:SOURce]:AM:FREQuency
 [:SOURce]:AM:FREQuency:STEP[:INCRement]
 [:SOURce]:AM:SOURce
 [:SOURce]:AM:STATe
 [:SOURce]:AM:WAVEform