Instructions

RIGOL Chapter 2 Front Panel Operations
2-36 DSG800 User Guide
File Type
In the store and recall interface, rotate the knob to select the desired storage
directory (available when a USB storage device is detected; it is used to switch
between D disk and E disk); then, press the right arrow key to unfold the current
directory. Press File Type to select the desired file type.
The file types available are "All", "State", "Arb", "Flat csv", "Swp csv", "Train csv",
"Segment", "Seg List" and "Seg csv". The default is "All". The description of each file
type is as shown in the table below.
File
Type
Format
Suffix
Explanation
State
BIN
.STA
Store the current system state in binary format.
Arb
BIN
.arb
The arbitrary waveform
[1]
wavetable file stored
in binary format. You can load the file when
necessary.
Flat csv
CSV
.CSV
The flatness list file stored in csv format. You
can open the file using Excel on the PC to view
the list information.
Swp csv
CSV
.CSV
The sweep list file stored in csv format. You can
open the file using Excel on the PC to view the
list information.
Train csv
CSV
.CSV
The train list file stored in csv format. You can
open the file using Excel on the PC to view the
list information.
Segment
BIN
.SEG
The Multisegment
[1]
wavetable file stored in
binary format. You can load the file when
necessary.
Seg List
BIN
.SEQ
The Multisequence
[1]
list file stored in binary
format. You can load the file when necessary.
Seg csv
CSV
.CSV
The Multisequence
[1]
list file stored in csv
format. You can open the file using Excel on the
PC to view the list information.
Note
[1]
: The wavetable files should be edited and downloaded to the RF signal generator via the
Ultra IQ Station PC software.
Tip: You can generate csv format files using Excel on the PC. Then, you can open the
file, edit the required parameter values (the unit is required to be added) according
to the corresponding file format requirements directly in the Excel table and save it
to a USB storage device. In addition, you can also load the file to the RF signal
generator when required.