Instructions

RIGOL Chapter 2 Front Panel Operations
2-46 DSG800 User Guide
I/O Configuration
The RF signal generator supports USB and LAN communication interfaces.
Press Syst  I/O Config to set the "Remote I/O" and "LAN" parameters.
1. Remote I/O
Press Remote I/O to select "LAN", "USB", "Auto" or "Off" (turn off all the
interfaces).
2. LAN
Press LAN to set the LAN parameters.
Figure 2-3 LAN Parameter Setup
 Reset
Turn DHCP and auto IP on and turn manual IP off; clear the network
password set and restore it to the factory setting.
 Apply
After configuring the LAN parameters, press Apply  OK and the
configuration takes effect.
 DHCP
One of the IP address setting methods. When DHCP it turned on, the DHCP
server will assign network parameters (such as the IP address, subnet mask
and gateway) for the RF signal generator according to the current network
configuration.
 Auto-IP
One of the IP address setting methods. When auto IP is turned on, the RF